Blog

Friday, 8 November 2019
Netio Products

NETIO PRODUCTS

Thursday, 7 February 2019  |  Admin
Structural health monitoring with the MonoDAQ-E-gMeter MEMS accelerometer DAQ Unit

MonoDAQ-E-gMeter is an all-in-one sensor and a data acquisition device with a very low noise 3-axial MEMS accelerometer. The MonoDAQ-E-gMeter has an EtherCAT interface and DEWESoft software support. Power and signal over the same cable allows it to be distributed all over the structure that requires acceleration monitoring.

Friday, 1 February 2019  |  Admin
The MonoDAQ-U-X USB Mulitifunction DAQ Unit - the Data Acquisition Chameleon

Are you looking for a Data Acquisition (DAQ) device to perform multichannel temperature, pressure, voltage or current measurements in a very limited time? Do you need to control and automate the measurement with analogue and digital output? Are you also tight on budget? If you answered yes, MonoDAQ-U-X is the right solution for you!

Thursday, 31 January 2019  |  Admin
Extend your RS485 Network Wirelessly

Bridge LR converts an RS-485 network to a wireless long range network LoRaTM. A system consists of a master bridge connected to a RS-485 master, and as many slave bridges as required. The communication between master and slaves is completely transparent to allow an easy installation. Bridge LR has a typical range of 1km indoor and 20km outdoor. 12VDC powered for remote battery applications.

Friday, 13 October 2017  |  Admin
New Exciting Products from ControlByWeb

New products released from ControlByWeb

  • X-410 - a new Web-Enabled Programmable Controller.With the X-410, you can control, monitor, and log up to 100 inputs and/or outputs from up to 32 remote I/O modules using the X-410's intuitive web interface.
  • XW-210 a Wifi version of the Web Relay  but it can also support 4 temperature sensors
  • X-TC1W-K - Thermocouple to 1-Wire Adapter for high temperature measurement applications
  • X-DTHS-P Temperature and Humidity Probe

Page 1 of 3    (14 Articles)
Latest News
Friday, 8 November 2019
Netio Products

NETIO PRODUCTS

Thursday, 7 February 2019  |  Admin
Structural health monitoring with the MonoDAQ-E-gMeter MEMS accelerometer DAQ Unit

MonoDAQ-E-gMeter is an all-in-one sensor and a data acquisition device with a very low noise 3-axial MEMS accelerometer. The MonoDAQ-E-gMeter has an EtherCAT interface and DEWESoft software support. Power and signal over the same cable allows it to be distributed all over the structure that requires acceleration monitoring.

Friday, 1 February 2019  |  Admin
The MonoDAQ-U-X USB Mulitifunction DAQ Unit - the Data Acquisition Chameleon

Are you looking for a Data Acquisition (DAQ) device to perform multichannel temperature, pressure, voltage or current measurements in a very limited time? Do you need to control and automate the measurement with analogue and digital output? Are you also tight on budget? If you answered yes, MonoDAQ-U-X is the right solution for you!

Thursday, 31 January 2019  |  Admin
Extend your RS485 Network Wirelessly

Bridge LR converts an RS-485 network to a wireless long range network LoRaTM. A system consists of a master bridge connected to a RS-485 master, and as many slave bridges as required. The communication between master and slaves is completely transparent to allow an easy installation. Bridge LR has a typical range of 1km indoor and 20km outdoor. 12VDC powered for remote battery applications.

Friday, 13 October 2017  |  Admin
New Exciting Products from ControlByWeb

New products released from ControlByWeb

  • X-410 - a new Web-Enabled Programmable Controller.With the X-410, you can control, monitor, and log up to 100 inputs and/or outputs from up to 32 remote I/O modules using the X-410's intuitive web interface.
  • XW-210 a Wifi version of the Web Relay  but it can also support 4 temperature sensors
  • X-TC1W-K - Thermocouple to 1-Wire Adapter for high temperature measurement applications
  • X-DTHS-P Temperature and Humidity Probe