Home > Data Acquisition and Control > Signal Conditioning > LabJack LJTick Modules
(Details shown apply to the default selection)
Availability:
2 in stock, immediate despatch
The LJTick-Divider (LJTD) is a signal-conditioning module designed to take 2 single-ended higher voltage analogue signals, and divide them down to 0-2.5 volt signals. The 4-pin design plugs into the standard AIN/AIN/GND/VS screw terminal block found on newer LabJacks such as the U3 and UE9.
The use of large resistors and a precision op-amp buffer provides an input impedance of 1 megaohm. By adding or replacing resistors, many other configurations are possible, as discussed in the datasheet.
Datasheet >>
LJ-CB37 - Screw Terminal Board£58.00
LabJack U3-HV - USB Multifunction Data Acquisition Unit - 10V Input Range£144.00
LabJack U3-LV - USB Multifunction Data Acquisition Unit - 2.4V Input Range£144.00
LabJack U6 - 14 Channel Multifunction DAQ Unit - 20 digital IO, Counters, Encoders£370.00
LabJack U6-PRO - USB 24-Bit 14 Channel Multifunction DAQ unit£462.00
Be the first to Write a Review for this item!
