MBIO-8DIO - 8 Digital Inputs, 8 Transistor Outputs

MBIO-8DIO - 8 Digital Inputs, 8 Transistor Outputs
Zoom  Zoom
Our Price:  £59.00(£70.80 Inc. VAT)

Digital Inputs:  8
Digital Outputs:  8

Availability:  

5 in stock, immediate despatch  

5 in stock, immediate despatch

Low-cost Modbus RS485 based remote IO units, which provide a simple way for integrating analogue or digital signals to supervisory SCADA systems. The MBIO-8DIO has 8 opto-isolated digital inputs and 8 open collector transistor outputs. Reduced price to clear.


Special Offer:  Discounts of 7%, 10%, 12.5% and 15% are available when you order 10, 25, 50 and 100 items or more of this product.

  • 8 Digital Inputs
    • 8 Digital Counters
    • Counter Resolution - 32 Bit
    • Counter frequency - 1 KHz (max)
    • Digital input 0 level -0 to +6.5Vdc
    • Digital input 1 level - +12Vdc to +24Vdc
  • 8 Digital Outputs 8
    • Type - NPN Open collector
    • Max Load Current - 100mA per channel
    • Max load Voltage - 36Vdc
  • Isolation (Field & Logic)     1500VAC RMS
  • Watch dog output timer     Disable or 1-255 sec  adjustable
  • Status Indication - LED per channel
  • Operating Temperature. -10°C to + 50°C
  • Power Supply - 12-24V DC (30mA @12V, 17mA @24V)
  • Dimensions - 100mm x 90mm x 25mm (excluding screw terminals)

The MBIO-8DIO module is an 8 channel digital input and 8 channel digital output module.

The inputs are isolated from the logic by bi-directional opto-couplers. The common is connected internally to either the -volts or +volts field power supply terminals using a jumper link which is situated inside the housing.

The module may be used as either a slave or master on the Modbus network. When used with a PC or PLC the module will be configured as a slave. When used with another MBIO-8DIO module in a point-to-point configuration, the DIP switch 9 must be turned on to set the module up as a master. In this mode the MBIO-8DIO module will automatically read/write the information from/to the other MBIO-8DIO module.

The inputs have internal counters associated with them. These counters are 32 bit counters allowing a count value from 0 to 4294967295. The count value can be cleared by writing a zero to the associated registers or preset to any other value using the same method. The counters can also be reset automatically when read. This is done by setting on DIP switch 9 on the front panel.

Note: The count values are not battery backed-up and will be lost if power is turned off.

Configuration Software

IOStudio is a free software package used to configure the communication settings for IO modules on the Modbus network. Once a module is detected, it is possible to view real-time data of the module directly on the PC and it can be used for diagnostic purposes as well.

 


Downloads

User Manual >>

IOStudio Config Software >>

 


Customers who bought this item also bought:


Continue ShoppingTell a Friend