Home Page Contact Us My Basket Checkout
Damocles-MINI Ethernet I/O Control
Description
The Damocles-MINI is an Ethernet based digital I/O alarm and control unit. It contains 2 relay outputs and 4 digital inputs which can be used to trigger email alarms. The inputs can also be configured as pulse counters, ideal for monitoring the output from flow, electricity, water and gas meters. You can monitor input status and control the relay outputs through your web browser or through software by using standard protocols such as Modbus TCP.
Product
Ethernet - RJ45 connection 4 digital inputs 2 relay outputs - relay contacts (NC and NO) Inputs can be set for 32-bit counter Simple web interface for configuration and control Open communications protocols (SNMP, XML, Modbus/TCP and others..) Can be used with SCADA software such as DAQFactory Alarm on input E-mail (SMTP) SNMP Trap SMS in GSM network (over supplied software) Free SDK (Software Development Kit) library with examples (Visual Basic, Delphi, C++, .NET ...) User Manual >>
Description
The Damocles-MINI contains 2 relays outputs and 4 inputs for connect the contact. You can monitor the values and control the outputs with your web browser or software using standard standard protocol. On input state change, the Damocles MINI will send an email or SNMP Trap. With the free supplied software, you can log the messages or redirect via SMS in GSM network. All inputs have the pulse counters. You can connect contact outputs from utility meters (electricity, water, gas).
Once the Damocles-MINI is connected to the Ethernet, you can run the free UDP setup utility, which will serch the LAN to find all attached devices. You can then specify your desired Network address parameters. Once this is done, you can simply acces the I/O data from a web browser. There is also a flash-based version - On-line Demo >>.
Alarms and Alarm Alert via Email The Damocles-MINI supports "Single Alarm“ and "Group Alarm“ modes; Single Alarm - you can configure each input to alarm on state change either from contact make-to-break or from break-to-make. The alarm can be sent to up to 2 separate email address or up to 4 SNMP trap destinations. Combinations of inputs can be specified as an Alarm condition in addition to the single alarm. Software The Damocles-MINI is supplied with a free SDK (Software Development Kit) library with examples (Visual Basic, Delphi, C++, .NET ...). The Damocles-MINI can also be controlled by any 3rd-party software that supports Modbus TCP/IP. More Information Here >>
Specifications
Ethernet port Interface RJ45 (10BASE-T) 10 Mbit or 10/100 Mbit network compatible Supported protocols IP: ARP, TCP/IP (HTTP, Modbus over TCP), UDP/IP (SNMP) SNMP compatibility Ver:1.00 compatible, some parts of the ver 2.0 implemented   Digital inputs 4x Contact inputs (Dry contact) contact directly (dry contact).   Digital outputs 2x Relay contacts up to 5A/110V AC or 5A/24V DC 1x NC and 1x NO for every output   LED Status indicators POWER Green - power OK LINK & Activity Green - Ethernet connectivity   DIP SWITCH configuration DIP1   Not used DIP2   - Security ON   = Security mode - remote configuration disabled OFF = Non-Security mode - remote configuration enabled   Physical parameters Voltage requirements 12-24 V/ 600 mA DC- coaxial power connector (barrel), GND on the shield Dimensions 35 x 101.6 x 76.2 [mm] (H x W x D )  Weight 500 g   Functional parameters Device SETUP configuration possibilities - UDP Config - IP address assign via UDP - TCP Setup - Terminal configuration and sensors management - WWW Setup - HTTP Flash application - SNMP (just for some parameters)
Phone +44(0)115 925 8412 | Fax +44(0)115 925 9757